Posts tagged “projects”

10 posts.

Project: How Do You Build an AXI4-Lite Peripheral?

A custom AXI4-Lite peripheral in Verilog with four registers, tested against 300 random transfers, and synthesized for a Zynq-7020 at 100 MHz.

14 min read

FPGA Project: Blink an LED on Basys 3, Arty A7 or DE10-Lite

The first FPGA project: a counter divides the board clock down to toggle an LED once a second. Verilog, constraints for three boards, and the Vivado results.

8 min read

FPGA Project: A Seven-Segment Seconds Counter

A four-digit BCD seconds counter on the Basys 3 and DE10-Lite displays: a carry chain, a segment decoder, and multiplexing four digits on one bus.

10 min read

FPGA Project: A UART Echo at 115200 Baud

Type on your computer and the FPGA sends every character back: the UART project's receiver and transmitter, a one-byte holding register, and three boards.

9 min read

FPGA Project: VGA Color Bars at 640 x 480

Generate 640 x 480 VGA timing and eight color bars on a Basys 3 or DE10-Lite: horizontal and vertical counters, sync pulses, and a 25 MHz pixel enable.

10 min read

Project: How Do You Verify an APB Slave in SystemVerilog?

A layered SystemVerilog testbench for an APB register slave: driver, monitor, scoreboard, coverage and protocol assertions, and the planted bug it caught.

14 min read

Project: How Do You Build an ESP32 CAN Bus?

Two ESP32 nodes on a CAN bus through MCP2515 controllers at 500 kbit/s: wiring from the datasheets, bit timing, and code that sends and replies.

14 min read

Lesson 7: How Do You Verify a FIFO End to End?

The course's final project: a constrained-random testbench for the synchronous FIFO with a queue model, flag assertions and coverage, and a planted bug.

12 min read

Project: How Does a Synchronous FIFO Know When It Is Full?

With one extra pointer bit. A synchronous FIFO in Verilog where equal pointers mean empty, plus a testbench model that checks 5,000 random cycles.

10 min read

Project: How Do You Build a UART in Verilog?

A UART transmitter and receiver in Verilog, 8N1 at 115200 baud from a 50 MHz clock, with mid-bit sampling and a loopback testbench that checks 104 bytes.

12 min read